When it comes to providing a lightning-fast internet, Netgear Nighthawk routers are at par. But, it can be irritating if your router won’t connect to the internet. Don’t worry! In this article, we will provide you some troubleshooting tactics that will help you fix the issue. But, before we do that, have a quick look at the reasons that are not allowing your Netgear router to connect to the internet.

Reasons Your Netgear Router Won’t Connect to Internet

A lot of reasons prevent your Netgear WiFi router from connecting to the internet. Below listed are some of them:

  • There might be a loose cable connection between your Netgear router and modem.

  • You might haven’t performed Netgear router setup properly.

  • Your Nighthawk router might be operating on an obsolete firmware.

  • The router might not be receiving a fluctuation-free power supply.

  • An issue with the router itself.

Now, let’s move to the troubleshooting tips that can help you fix the ‘Netgear router not connecting to internet’ issue.

Fixed: Nighthawk Router Won’t Connect to Internet

  1. Check the Connections

Chances are that a valid internet connection is being supplied by your Internet Service Provider but it is unable to reach your router. In such a situation, do the following things:

  • Check all the cables connected to your Nighthawk router.

  • If there is a damaged Ethernet cable, then it is advised to replace it with a new one so that you can enjoy a seamless internet.

  • Above all, make sure that the connection are finger-tight and precise.

  1. Reboot the Entire WiFi Network

Sometimes, Netgear WiFi routers cease to work properly due to excessive usage. Perhaps the same thing happens with your modem and WiFi-enabled device too. Thus, in such a situation, reboot the entire WiFi network. It means you have to reboot all your WiFi devices. For this, turn them off and remove all the wired connections. Allow your WiFi devicesto stay idle for some time and turn them on. Check if the issue resolves. If not, then go to the next troubleshooting tip.

  1. Update the Firmware

An outdated firmware of your Nighthawk router also won’t allow it to connect to the internet. Therefore, it is recommended to update its firmware regularly. To update the router’s firmware, refer to the Netgear user manual and follow the steps.

  1. Reset and Reconfigure

If none of the troubleshooting tips have worked so far, then don’t feel out of luck. You can still fix the issue. All you need is to restore your Nighthawk router to the factory default settings. Performing factory reset will erase all the saved settings from your router. To factory reset your WiFi device, follow these steps:

  • Turn on your Netgear Nighthawk router by plugging it into a working wall outlet.

  • After the power LED on your router stabilizes, look for the Reset button.

  • Once found, pick a paper clip or an oil pin and press the Reset button with its help.

  • As soon as you release the button, your router will be restored to its factory default settings.

Now, check if the Internet LED on your Nighthawk router glows green. If yes, it means the issue has been resolved and you can reconfigure your WiFi device by accessing the Netgear router login IP.

Summing Up

We hope that you will be able to fix the ‘Netgear router not connecting to internet’ issue by following the aforementioned troubleshooting tips. If none of them worked for you, then chances are that your router is damaged. Therefore, replace your router and perform new router setup by accessing the Netgear Nighthawk login page.