NC LIGHTING is the best lighting solution for all projects: gardens, town streets, public buildings, factories, amusement parks, schools, industrial parks, hospitals, airports…
The process of supplying light poles at NC LIGHTING includes the following steps:
Absorb buyer’s request for street light pole: inform about parameter size, quantity, model line, installation address.
The technology department receives the notice from the buyer’s sales department to plan the drawing of the column that they are about to provide, and calculate the details based on the column calculation software.
lighting steel pole production process
Format the required corrugated iron volume for equipment => Conduct corrugated iron cutting by automatic cutting machine.
After cutting the corrugated iron, the column will be fixed, if it is an octagonal column, then use an octagonal base, if it is a conical round column, you must change the octagonal base to a conical circle and begin to stabilize, while paying attention to keep the corrugated iron sheet firmly fixed. Avoid the case that the corrugated iron is too long, causing the finished column to be twisted (Depending on which column line is used, the base of the sample column is used)
The 12m bending machine works completely in automation with modern technology, minimizing labor distribution and avoiding most technical errors, producing beautiful finished products with scientific and correct appearance. customer loyalty.
After finishing, each column will be transferred to an automatic lamp column welding machine, pay attention to adjust the amount of welding, the welding line is straight and the amount of CO2 is just enough so that the weld is not large and bubbling. foam during welding. When the welding is complete, these columns will be transferred to a new stage, which is welding the column base (Into the base).
Detail drawing of lighting steel column design
The column base usually has a large base line (KT 400x400x10, length x width x thickness) and small base line (300x300x8) depending on the size ordered by the customer, we proceed to cut the sheet to the correct size on the drawing, after cutting enough numbers. When it comes to quantity, punching and punching holes are carried out and usually run holes are used to catch the footing of the foundation frame buried in the ground more conveniently. When we have finished welding the sole, we proceed to weld the stiffening tendons for the column, which is usually 4 stiffened ribs for the basic columns, and the complicated columns, depending on the drawings sent to you by the customer, for proper welding.
When finished, we should sharpen the welds that are not beautiful again to look really good to conduct hot-dip galvanizing (note that most columns must have a small hole in the bottom of the base. column) After hot-dip galvanizing, we proceed to straighten the light pole (with automatic straightening machine, we just need to observe and press the button) the last step to complete a light pole is bending the column. The column reaches 1.2m or 1.5m, which we bend to match the size proposed by the customer.
lighting steel column design thiết
The process of distributing light poles is just that, but when it comes to practice, all problems arise. Before you intend to distribute this lamp post, you should consider it carefully and go to the factory to see it in person, it will be much better.
Above is the process of supplying standard (basic) light poles, but there are many more complex types of columns such as THGT poles or columns Installed in cast iron bases, please follow in the next articles.
