Netgear Orbi pro routers are known to provide the internet speed and range that people have always desired. However, sometimes, Orbi pro routers lack perfectionism. In simple words, we mean, Netgear Orbi routers have been troubling users for quite some time now. And that is because of one specific issue: Netgear Orbi pro dropping connection.

If you have set up an Orbi pro device by accessing the orbilogin page, then there is a high possibility that you are experiencing the same issue. However, before you start worrying, let us tell you that we are here to help. In this post, you will find some sure-fire ways through which fixing the issue at hand will become a five-finger exercise for you. Thus, scroll down and get to reading.

Fixed: Orbi Pro Dropping Connection Issue

  1. Get Rid of Faulty Ethernet Cable

A damaged Ethernet cable is one of the topmost reasons that might have caused your Netgear Orbi pro router to drop the connection. To troubleshoot the issue, we recommend that you replace your Ethernet cable with a new one.

Although doing so might resolve the issue for you, however, if you are stuck with the same, then connect your devices using a wireless source.

  1. Check the Power Socket

Insufficient power supply or power malfunction can also cause the Netgear Orbi pro dropping connection issue. Therefore, have a look at the wall socket into which you have plugged your Orbi pro router.

If you find that it is damaged from anywhere, take our advice and plug your Orbi pro router into a different wall socket. Ensure that this one is working.

  1. Call Your Internet Service Provider

There is a possibility that you are experiencing the Netgear Orbi pro dropping connection issue not because of something that you did. Perhaps your Internet Service Provider is not dedicated while working.

To confirm the same, give a call to your Internet Service Provider. If he does confirm that the issue is from his end, then rather than scolding him, give him some time to resolve it.

  1. Reboot Your Orbi Pro Router

You can try to reboot your Netgear Orbi pro router in order to troubleshoot the Orbi pro dropping connection issue. In simple words, you need to turn your Orbi off and on. Can you do that much? Yes? Good.

Once you are done rebooting your wireless device, check if the issue at hand has bid farewell to you. If it hasn’t, then it is recommended that you move to the next hack.

  1. Update the Netgear Orbi Firmware

If the Netgear Orbi pro dropping connection is still not leaving you alone, then you need to perform Orbi firmware update.

You can execute this process using two different methods. They are as follows:

  • Via Manual method
  • Using the Nighthawk app

If you need help in updating the firmware of your Netgear Orbi router, it is recommended that you refer to the guidelines given in the user manual.

  1. Perform a Hard Reset

If nothing has worked for you so far, then it is recommended that try the last hack, i.e. performing factory default reset.

Follow these instructions in order to restore your device to its default factory settings:

  • Locate the factory reset button on your Orbi pro router.
  • Press the button once found.
  • Wait for some time.

Now, you need to reconfigure your Netgear Orbi pro router considering it has gone back to its default factory mode.

Sum Up

Let us hope that the aforementioned troubleshooting hacks helped you rectify the Netgear Orbi pro dropping connection issue.

Which was the hack that actually helped you fix this issue? Do share with us by dropping a comment in the section below.