On a large construction site, a hydraulic hammer can be an essential tool as it helps in demolition and excavation of large rocks. It is a big investment and anyone that buys it would like to get the best out of it. With the right utilization and maintenance that is a possibility and if you are replacing any parts, they should be the right JCB backhoe parts if it is to function properly.

There are certain things that you must do and others that you must avoid if you want your hydraulic hammer to work efficiently and last longer. In this article, we shall highlight those things as we have already mentioned the importance of original JCB backhoe parts and other spares that you might need. Let us start off with the things you need to do.

Hydraulic Hammer Dos

Start at the Edge: When demolishing or breaking, start at the edge where it is easier for pieces to come off and then work your way to the center. It may be enticing to start from the center but that will not get the best results.

90 Degree Angle: Position the tool at a 90-degree angle as you strike the object, this provides optimum force and saves the tool and other parts from breaking in the process of chipping at the block.

Apply Grease: The hydraulic hammer is composed of moving parts and the tooltip is one of the most active parts. To get the best out of most moving parts, you need to ensure there is a generous amount of grease on it. Before you put the tool bit into the hammer, apply grease.

Alternate Strike Position: As you use the hammer, ensure that you do not strike the same position for more than 20 seconds, keep on changing after 10 to 20 seconds.

Secure the Tool bit: It is important to ensure the tool bit is firmly secured with limited movement between the bushes. If it is loose there is a risk of breakage.

Avoid Rust: When storing the tool bit, ensure there is no moisture where it is kept. After cleaning, wipe off any water which may cause rust.

Warm-up: When operating in cold environments, the tool will need to be warmed up before you put it to use since the cold temperature affects optimum performance. Start with light breaking before you get into the big job.

Causes of Damage

It is not uncommon that in the middle of a job, the tool bit breaks and the work grinds to a halt as it gets fixed. Knowing the causes of such damage can help prevent delays and losses. The main cause of preventable damage is the improper use of the tool. We already mentioned that it should be used at the right angle and not as a mover of objects as that will stress it.

Overuse can also be a cause of damage as it can cause the tool to heat up to a temperature that will stop it from working well or even
stop it from working completely.

Here’s Why Timely Lubrication Matters

Forgetting to lubricate the tool bit can be another cause of damage. A poorly lubricated tool can be subject to tension which will affect the way the tool operates and the vibration will be insufficient to effect breaking of structures. If you note a loss in vibration, stop using the tool immediately and check the lubrication.

In general, the causes of damage are two. The first one is the way it is used. Misusing any tool, not just a hydraulic hammer will cause damage in the short or long run. Misuse may cover a number of things including trying to use it for a different function like earth movement. The second cause is the failure to maintain the tool. If you do not carry out periodic maintenance, many parts will start to reduce efficiency until they stop working altogether. Choosing the wrong spare parts can also cause damage to other parts especially if the parts are not compatible. It is a good idea to find genuine manufacturers and have experts carry out repairs and replacements.

After spending a considerable amount of money to purchase a hydraulic hammer, you should be able to enjoy the best performance from it.
Following the tips above can ensure that you are able to. There is no reason for it to end up getting spoiled after just a short while. If you find any challenges, feel free to seek expert advice on how to overcome the challenge. There are a number of experienced handlers and technicians who are willing to share important maintenance tips at no charge, make use of them and get the best of your hydraulic hammer.