Demister Pads Manufacturer and Supplier by LNT Industrial Engineering Services
Carry over of particulate matter by gas or vapour, generally termed as “Entrainment” is commonly encountered in Gas-Liquid separations. In many leading industries, Demister Pads have gained acceptance as a low cost and highly efficient means of separating Entrained liquid droplets from gas and vapour stream. Because of simplicity of construction, Demister Pads can be easily made to any shape and size to suit process configuration in existing or new equipments.
Product Details :
When properly designed Demister Pads can give Efficiency up to 99.9% with minimal pressure drop. Normally Demister Pads can remove droplets down to 5microns and lower with a free volume of up to 99% and a surface area of up to 1940 m2/m3. Due to high value of free volume the pressure drop across the demister pad is sufficiently low, negligible for most applications.
- Solves Emission control Problems.
- Eliminates or reduces damage caused to the equipment due to corrosive liquid droplets.
- Recovery of valuable liquids.
- Improves purity of gas/vapour for further processes.
- Improves overall process economics.
- Increases process efficiency.
Demister Pads are essentially porous blankets of carefully knitted wire or synthetic fibers designed and constructed to efficiently abate mist particles. After knitting each layer is corrugated and converted into Pads of different shapes and sizes. The Demister is generally supported by Grids as they are not entirely rigid.
Demister Pads are installed at some distance above the surface of liquid allows free disengagement of mist droplets and the coarsest particles. The vapour/gas-liquid mixture run at a predetermined velocity through the Demister Pad, the vapour/gas finds an open path through the mesh easily, but due to greater inertia the droplets and mist impinge on the mesh and gradually increase to a bigger size and fall down due to gravity allowing the vapour/gas to pass freely without any Entrainment from the top of the Demister Pad.
Materials of Construction:
Demister Pads are made of a variety of Materials as per application demands. A few materials of construction would be Synthetic fibres like Polypropylene (PP), PTFE (Teflon), Fluorinated ethylene propylene (FEP), Perfluoro alkoxy alkanes (PFA), Ethylene tetrafluoroethylene (ETFE), Polyvinylidene fluoride or polyvinylidene difluoride (PVDF), Non Ferrous Metals like Copper, Aluminium, Nickel, Brass, Phosphor Bronze, and Ferrous Metals and other special materials like Stainless Steel 304, Stainless Steel 316, Monel, Inconel, etc, for different applications like corrosive services, nitric acids, water solutions, Freon, alcohols, fatty acids, corrosive chemicals, food products, hydrocarbons, caustic soda, dilute acids etc,