The internet coverage wireless router is not so good as it can’t cover all the large areas of your house or offices. Due to this problem user’s can’t access proper internet and enjoy high speed internet connectivity just by staying near to the router range. After moving away from the router the range will also get weak and your device will no longer connect with the router network. As well as also suffers from buffering issues. If you wish to use a high range network and stable connection you can install a devolo wireless range repeater in your house and connect with your wireless router. The network connectivity of this repeater is ultimately best and covers a huge area. By using the network range of this device you can easily stay connected in any corner of your house.
This devolo wireless range repeater boosts the network range of your wireless router and eliminates the weak spots. It is the best for your access point, Standard router, cable and modem. If you are getting low network coverage by using this device can easily enjoy a superfast speed of live streaming, Online gaming and perform all internet activity without any issues. The devolo extender setup is so simple and fast. You can simply insert the power cord of your device into the electrical outlet and switch it “ON”. Just in 2 minutes by using WPS setup can use the device.
Causes of Devolo wireless range repeater no internet
The devolo range extender provides a huge range and dead zones free network area. It will boost the network signals and transmit to your wireless device. But sometimes user’s must face some common problems like “not connecting to the internet” and the devolo wireless range repeater is not amplifying the signals. In order to know the reasons or solutions you can read the given instructions :
- Repeater is not connected to the wireless router.
- Wrong MAC address configured.
- Extender placed too far from your router.
- Broadband modem not connected.
Ways to fix : No internet issues
If there is no internet in your devolo wireless range repeater, You can easily fix these issues by following the instructions manually that are given.
Disconnect router with your repeater
To fix the no internet issue you must verify that your wireless router is connected with the devolo wireless range repeater. If not connected then the internet will not work, It will show ‘NO INTERNET”. You must need to disconnect your router with the repeater and wait for some time then again try to reconnect it. Place your repeater nearby to the router and connect it wireless or wired (Using an ethernet cable). To configure your router with an extender you can also use the WPS method, Simply press the WPS button of your extender using a sharp nip. In the same manner, Press the WPS of your router and it will connect automatically and start working.
Remove the cookies and cache
Sometimes due to too much cache and cookies the problem can occur. In order to fix the issue you must clear all the cache and cookies. This can be done by opening any web browser and in the URL box type for http//devolo.wifi It will take you to the login panel. Make login using your credentials and open the device settings, Then tap on the ‘Cache” option, Then clean it properly. Not check if it will work or not.
Use ethernet connection
If you used the WPS method to set up your device. Sometimes it may not stay connected longer. So you can establish an ethernet connection, By using the ethernet port. An ethernet connection allows you high speed connection and superfast connectivity. To make ethernet connection, Take an cable then insert on the port of your extender which is available on the back side. Connect the other side with the router ethernet port. It will start work.
Reset devolo wireless range repeater
If all the given steps do not work and still you are facing the same problem. You have a last option left that one is factory reset. But keep in mind. The factory reset process will erase all your configured data and you must need to configure your repeater again.
How to reset?
In order to reset press the “RESET” button which is available on the back side of your extender. Just press it for 30 seconds until the LED indicators start to misbehave. Then release the button, Your extender will automatically enter on the reset mode and after some time it will be ready to configure again.
