Though limestone floors are always known for their high durability, they will eventually require refinishing. In areas of the floor that get a great deal of traffic, the tiles can eventually become discolored and grouting between the tiles can start to wear out, causing irreparable impairment. Every three years or so, a limestone floor should be refinished to keep up its high durability and attractive look. Refinishing a limestone floor is something that demands a few special materials as it is something standard cleaners can no longer remedy.
Step 1 – Prepare the floor:
Buy an appropriate acid-based Limestone Cleaner product UK. Make sure you purchase enough to cover the whole floor area. You should ideally refinish the entire floor so this means getting away with all furniture from the room. If there is any furniture that cannot be relocated, such as built-in units, you will require to make sure these are rightly covered before beginning. The chemical cleaners you will be using can cause long term damage to the surface of many furniture items.
Step 2 – Apply the Acidic Floor Cleaner:
Work systematically from one corner of the room to the other. Apply the Limestone cleaner to the floor, covering the tiles soundly. You should use rubber gloves before you control any cleaning products. Ensure the floor cleaner equally covers the entire floor. Scrub using a brush on the areas which have a great deal of dirt on them. The grouting lines should also be thoroughly cleansed. Wash the floor and leave it to dry.
Step 3 – Seal the floor:
Depending on the type of stone sealer that you buy in, you may either have to apply it once and let the tiles to absorb it or you may need to apply it in multiple layers. Refer to the manual on the packaging. Using a specially planned applicator pad to apply the sealer is by far the most convenient method. You can use a fabric or sponge. Work in one little section at a time, gushing small amounts of the sealant and scattering it evenly around the surface. Cover both the tiles and the grout joints exhaustively, disseminating the sealant in a circular manner.
Step 4 – Finish the Job:
The floor should be left to dry nightlong before walking on it or moving any of the piece of furniture back into the room. When you are contented that the floor is completely dry, you can then move any rugs and furnishing back into the room. You can proceed after this using standard floor cleaning methods. The surface should not want to be refinished for another five years.
However, refinishing a limestone tile countertop is an easy process that will bring the primary look and appeal of the limestone back to its original regime. Limestone is a soft component that takes a little extra care. Since it discolors fairly easily, it has to be cleansed using a Limestone Cleaner products UK before it can be coated with a sealant. Work as quickly as you can so that the sealant does not get down to dry as you apply the next row. This will ensure even coverage as well as venting any lines from forming that will be seen after the sealant gets air-dried.
