## INTRODUCTION

In case you’re intending to chip away on a roof and don’t have the structure plans, taking pioneer estimations from the ground lets you precise the roof region and measure a few expenses. Estimating your roof is the initial phase in an effective re-roofing task. You can get a measure of your roof’s estimations from the ground if you prefer not to ascend a ladder and get up on the rooftop yourself.

There is a specific method to measure the roof from the ground, which can be beneficial to know as regular check-up assistance provided by the property preservation company can reduce the damages that occur during extreme weather conditions.

1: Discover the length and width exterior wall: Use your measuring tape along the walls from one end to the other from both ways. Record these calculations in your journal. Alongside the roof’s angle, you’ll utilize these 2 measurements to ascertain the roof’s general square footage.

After estimation of the building’s walls, gauge the length of the extensions on one or the other side (if your roof has overhangs).

Evaluating the region from ground level is less exact than estimating each side exclusively, however, it can make a speedy, simple, and safe elective while re-trying a square or rectangular roof. To calculate an irregular roof, you’ll need to get on top.

2: Ascertain the pitch of the roof: To determine the pitch of your roof, you’ll initially have to set up a stepping stool adequately high to reach it. Spot a level against the roof a couple of feet in from the edge and point it with the goal that the drifting air pocket is focused, then, measure the length from the finish of the level to the exterior of the roof.

3: Pitch multiplier table to estimate out what number to use:

Pitch multiplier tables make it simple to use a specific pitch to assess the roof area. Run a quest for “pitch multiplier table” and search for the estimation of your roof’s pitch in inches on the left part of the table. Record the similar pitch multiplier to use in your after calculations. For instance, a roof with an ascent of 3-in-12 will have a pitch multiplier of 1.031, while one with an ascent of 8-in-12 will utilize a multiplier of 1.202.

You can have the option to of various solid pitch multiplier tables with a fast Internet search.

4: Increase the region by the pitch multiplier to get the roof area: To begin with, multiply the length by the width. Then, at that point, take the result of these two measurements and multiply it by your pitch multiplier. The number you get will be an exact measure of the region you need to cover for your roofing task.

5: Divide your assessed area by 100 to determine your materials. Roofing materials are packaged in “squares” that contain sufficient shingles to cover 100 square feet (9.3 m2). Partitioning 1,290 sq ft by 100, for instance, will tell to you that you need to arrange at any rate 13 squares to take care of work.

RPR Services is a property preservation work order processing and updating company, who provide all types of data processing for REO servicers and inspections QC and processing services to National, Regional, and Inspection Companies.